Our company's compressed air system has passed through oil and water filters and passed through cold water, but the air at the point of use still has oil. how can I remove 10? If there is oil at the end of use, the reason is that the filtration is incomplete, the oil and gas separator is faulty, and the load (not unloaded) is stopped.After knowing the correct reason, solve it in a targeted manner. The oil-water separator or filter is not high in precision, and a few more filters with higher filtration accuracy can be added, or a high-precision filter element can be replaced. If the oil is not water, the filter should not be configured. Replace the filter element or add the filter behind the cold box. To be honest, you have to add a precision filter behind the cold box.
What is the filtration method and principle of activated carbon rod filter? The activated carbon filter element is heated and sintering by adding activated carbon particles to the binder.The innermost layer of the filter element is polypropylene skeleton,To strengthen the pressure resistance of the filter element.There are two layers of polypropylene microfiber felt on the skeleton,It can intercept the liquid and bring out particles greater than 10 microns through the carbon core.The outer layer of the fusion filter element is covered with two layers of polypropylene microfiber felt,Can intercept the liquid to be greater than 10-20 micron particles,The filter element has the dual function of filtration and purification.The outermost layer is the white plastic mesh sleeve,The filter element has a complete appearance and a neat appearance.The two ends of the filter element are equipped with soft rubber end caps,After the filter element is loaded into the filter cartridge, it has good sealing perf